On site protection of hardwood flooring

The hardwood flooring should be installed as close as practicable to the end of a project.

The hardwood floor should be protected after installation from moisture conditions and working practices. It is best to use good supervision and temporary covering in working areas. Clean dustsheets and hardboard should be used carefully and then cleared between jobs to expose the floor. This will encourage respect of the floor and highlight any damage as well as the persons responsible.

Selected persons who are aware of safe operating temperatures and procedures for the hardwood floor should be the only ones authorised to adjust settings.

Permanent boarded covering may cause condensation and damage the floor.
Any dust, grit fixings etc that may find their way under the boarding will go unnoticed until close to hand over and could cause severe damage.